2gig 319-345MHz Dual Receiver

by 2Gig
Price: $64.00
  • GE-compatible 319 MHz wireless protocol
  • Accepts up to 48 wireless devices using 2GIG, Honeywel, or GE protocols
  • External antenna provides reliable range performance
  • Integrates into the panel itself, so no need for an external power supply
  • No need to hide additional translator hardware
  • Easy to install into any Go!Control panel
See more product details
The 2GIG 319/345 MHz Receiver is designed to be installed into the 2GIG Control Panel. This Receiver is
a dual frequency device, enabling communication between the Control Panel and peripheral devices that
use either the 319 or the 345 MHz frequency.

IMPORTANT: This 319/345 MHz Receiver excludes the use of the 2GIG-TS1 Wireless Keypad and Image Sensor since it utilizes the same port as the 900Mhz transceiver.

FEATURES
SETUP • GE-compatible 319MHz wireless protocol
• Accepts up to 48 wireless devices using 2GIG, Honeywell, or GE protocols
• External antenna provides reliable range performance
• Integrates into the panel itself, so no need for an external power supply
• No need to hide additional translator hardware
• Easy to install into any Go!Control panel
All currently supported 345MHz sensors will continue to communicate to the Go!Control.
319 MHz wireless
BEFORE INSTALLING
1 Disconnect the power from the Control Panel.
 1a Un-plug the AC Power Supply.
 1b Open the Control Panel.
 1c Disconnect the backup battery.
2 To disconnect the 900 MHz Transceiver Module
inside the Control Panel, pull straight up. (FIG.1) If
you don’t pull the module straight up, there is a
danger of breaking either the 3-pin or 5-pin
connectors.
TIP: The module is located behind the Home Button on
the main circuit panel. INSTALLING THE 319/345 RECEIVER
1 Align the 319/345 MHz Receiver to
the 3-Pin Connector. (FIG.2)
2 While maintaining previous
alignment with the 3-pin
connector, align the 319/345
Receiver to the 5-pin Connector.
3 Press down on the foam pressure
pad to seat the receiver. (FIG.3)
4 After the receiver is properly
seated, hold the receiver in place
(in the control panel) while
inserting the antenna plug fully
into the 319/345 MHz Receiver
antenna mating connector.
MOUNTING THE ANTENNA
1 Thread the antenna through the
back of the Control Panel into the
wall (FIG.4).
2 Reconnect the battery.
3 Close the Control Panel.
4 Plug in the AC Power Supply.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

We accept PayPal. Visa, MasterCard, Discover, and American Express are accepted via Paypal.

Paypal_verified